При подаче жидкости от источника питани во взвод щие полости В и D ударна масса 6 и инерционный поршень 2 начинают двигатьс навстречу друг другу, сжима соответственно газ в аккумул торах Е и А (обратный ход). Движение масс продолжаетс до момента, когда перекроетс отверстие 9 ударной массой 6. Далее жидкость из полости С вытесн етс ударной массой 6 в канал И; воздейству на плунжер 7, перемещает его, сообща взвод щие полости D и В со сливной С через каналы 10-12. Давление в этих полост х выравниваетс и становитс равным сливному. Тогда под действием сжатого газа аккумул торных полостей А и Е инерционный поршень 2 и ударна масса 6 начинают двигатьс ускоренно в противоположные стороны (пр мой ход}.When fluid is supplied from the power source to the charging cavities B and D, the shock mass 6 and the inertial piston 2 begin to move towards each other, compressing the gas in the E and A batteries (reverse stroke), respectively. The movement of the masses continues until the opening 9 is blocked by the shock mass 6. Next, the fluid from the cavity C is forced out by the shock mass 6 into the channel I; I act on the plunger 7, moves it, together cocking the cavities D and B from the drain C through the channels 10-12. The pressure in these cavities is equalized and becomes equal to the drain. Then, under the action of the compressed gas of the battery cavities A and E, the inertial piston 2 and the impact mass 6 begin to move rapidly in opposite directions (forward motion}.
В конце пр мого хода ударна масса 6 наносит удар, а плунжер 7 управлени под действием пружины 8 и сил инерции перемещаетс в направлении движени ударной массы 6 и перекрывает канал 10.At the end of the forward stroke, the shock mass 6 strikes, and the control plunger 7, under the action of the spring 8 and the inertial forces, moves in the direction of the shock mass 6 and closes the channel 10.
Затем инерционный порщень 2 начинает тормозитьс .за счет вытеснени жидкости из взвод щей полости В в полость D, одновременно перемеща ударную массу 6 в направлении обратного хода и сжима газ в аккумул торе Е. После останова ударной массы 6 и инерционного порщн 2 жидкость в полости D запираетс обратным клапаном 5. Рабоча жидкость, поступа от источника питани , перемещает инерционный поршень 2 «лево по чертежу, сжима газ в аккумул торе А.Then the inertial piston 2 begins to decelerate. Due to the displacement of fluid from the charging cavity B into the cavity D, simultaneously moving the impact mass 6 in the direction of reverse and compressing the gas in battery E. After the shock mass 6 and the inertial pressure 2 stop, the liquid in the cavity D it is closed by a check valve 5. The working fluid, coming from a power source, moves the inertial piston 2 "left in the drawing, compressing the gas in accumulator A.
При давлений газа в аккумул торе А, близком конечному, откроетс обратный клапан 5 и жидкость от насоса поступит в полость D. Затем начнетс синхронное движение инерционного поршн 2 и ударной массы 6 (обратный ход) до момента, когда ударна масса 6 перекроет сл вное отверстие 9. Далее цикл повтор етс .At gas pressures in accumulator A, close to the final one, the check valve 5 opens and fluid from the pump enters cavity D. Then the synchronous movement of the inertial piston 2 and impact mass 6 (reverse stroke) begins until the impact mass 6 closes the air outlet 9. Next, the cycle repeats.