Claims (2)
1. Способ подготовки концов труб под сварку при замене дефектного участка магистрального трубопровода, заключающийся в разметке и резке по разметкам концов "катушки" и ремонтируемого трубопровода, сравнении размеров и форм соединяемых концов труб, обеспечение совпадения кромок труб, отличающийся тем, что сравнение размеров и форм соединяемых сваркой концов труб производят с кругом-эталоном, диаметр которого равен номинальному диаметру ремонтируемого трубопровода, а обеспечение совпадения размеров и форм концов труб производят до монтажа "катушки" путем пластической деформации металла труб действием на стенку труб по всему его периметру распределенного усилия до достижения сечений концов труб формы круга и равенства их диаметров.1. The method of preparing pipe ends for welding when replacing a defective section of the main pipeline, which consists in marking and cutting according to the marking of the ends of the “coil” and the pipeline being repaired, comparing the sizes and shapes of the connected pipe ends, ensuring the coincidence of the pipe edges, characterized in that the comparison of sizes and forms of pipe ends connected by welding are produced with a standard circle, the diameter of which is equal to the nominal diameter of the pipeline being repaired, and ensuring the coincidence of the sizes and shapes of the pipe ends is carried out before installation Ms "coil" by plastic deformation of the metal pipe effect on pipe wall around its perimeter distributed effort to reach sections of the pipe ends form a circle and equality of their diameters.
2. Способ по п. 1, отличающийся тем, что действие распределенного усилия в зонах, находящихся внутри размера номинального диаметра труб, направляют от центра трубы, и в зонах, находящихся за размером номинального диаметра труб, - в центр трубы, а интенсивность распределенного усилия в каждом сечении трубопровода устанавливают в зависимости от величины отклонения фактического сечения от номинального диаметра, толщины стенки и диаметра труб. 2. The method according to p. 1, characterized in that the action of the distributed force in the areas inside the size of the nominal diameter of the pipes is directed from the center of the pipe, and in the areas beyond the size of the nominal diameter of the pipes, in the center of the pipe, and the intensity of the distributed force in each section of the pipeline set depending on the deviation of the actual section from the nominal diameter, wall thickness and pipe diameter.