Cups driver for Phomemo M02 Pro. Based on the works of other, but tweaked and cleaned up for my setup, which is a raspberry pi zero. See full instructions below.
- Get a good power supply for your raspberry pi. If your image starts out printing fast but then slows down, you do not have enough power.
- Download the Raspberry Pi Imager tool.
- Use it to create a disk image for your pi. I used rpi lite 64bit with no desktop (available on page 2).
- Install dependencies
sudo apt-get update
sudo apt-get upgrade
sudo apt-get install cups python3 python3-pip python3-devel python-pil3 python3-dbus python3-bluez bluetooth bluez blueman netatalk git
# idk which bluetooth modules are actually necessary. netatalk and git is also just for me
- Restart bluetooth
sudo rfkill unblock bluetooth
sudo systemctl stop bluetooth
sudo systemctl status bluetooth
sudo systemctl restart bluetooth-
Check for your printer
hcitool scan -
Test connect
sudo rfcomm connect 0 53:48:0D:83:AA:69 -
Add your user to cups
sudo usermod -a -G lpadmin submarines -
Configure cups for network access
sudo nano /etc/cups/cupsd.conf
# Change "Listen localhost:631" to "Port 631"
Listen localhost:631
Port 631
# Add retry interval (optional, default is 30)
JobRetryInterval 10
# Add Allow @local to the following sections
<Location />
Order allow,deny
Allow @local
</Location>
<Location /admin>
Order allow,deny
Allow @local
</Location>
<Location /admin/conf>
AuthType Default
Require user @SYSTEM
Order allow,deny
Allow @local
</Location>-
Restart cups
sudo /etc/init.d/cups restart -
Auto connect cups to network after reboot
sudo nano /etc/network/if-up.d/cups
#!/bin/sh
sudo systemctl restart cups.service- Make executable
sudo chmod +x /etc/network/if-up.d/cups
- Build cups drivers
make
sudo make install- Install drivers
# To add
sudo lpadmin -p M02 -E -v phomemo://53480D83AA69 -P /usr/s
4E35
hare/cups/model/phomemo/phomemo-m02pro.ppd.gz -o printer-error-policy=retry-job
# To remove
sudo lpadmin -x M02If all went well, the printer should now appear on all your apple devices. If you change the cups/backend/phomemo.py file to suit your setup, re-running make+sudo make install is enough to run your new code. For cups error logs: tail /var/log/cups/error_log -f - they are not the best.